Beskytt gassturbinen mot isdannelse under høy luftfuktighet og lave temperaturer
Anti-icing mechanisms are generally used on gas turbine inlets when the air temperature is below 5 °C and the relative humidity is above 70%. Insufficient icing protection may result in inlet filter system issues and ice formation at the turbine inlet.
to mitigate these risks, there are various anti-icing options show in Table 1, where location, heat capacity, and functionality for each option is outlined.
|Anti-Icing Option||Location||Heat Capacity||Functionality|
|Pulse System||Filter protection only||None||Cartridges pulse snow and thin ice off filters.|
|Heat Exchanger: Heating Coils||Upstream or downstream||Limited by heat source availability: Target is to heat the air by +/- 10°C||Heating coils pump fluid such as steam of glycol with water to heat inlet components and can be operational even before starting the engine.|
|Hot Air: Ventilation||Upstream or downstream||Limited by heat radiated by the engine in the enclosure: Target is to heat the air by +/- 10°C||Ventilation air from the enclosure is reused through a ducting system to warm the incoming air. Electrical heaters may be required to increase the temperature if the air is not warm enough.|
|Hot Air: Exhaust||Upstream or downstream||Unlimited: Target is to heat the air by +/- 10°C||Ducts, dampers, and fans direct hot air flow from the exhaust, mixed with ambient air to the inlet.|
|Hot Air: Compressed Bleed||Upstream or downstream||Limited by the OEM spec. Target is to heat the air by +/- 10°C||Hot air is sent through pipes from the gas compressor bleed, and is distributed through anti-icing rakes in the opposite direction of the airflow.|
|Heat Surface: Infrared||Surface protection only||Limited by electrical power availability. Heats only the surface to 20-30°C and does not heat the air||Infrared heaters are installed in front of filters to prevent ice formation. They heat the surface by radiation and do not heat the air significantly.|
|Electrical Resistance||Upstream or downstream||Limited by electrical power availability. Target is to heat the air by +/- 10°C||An electrical heater is used for anti-icing. They can also be installed on metal vanes.|
|Heated CamVanes||Vane protection only||Limited by electrical power availability. Target is to heat the vane surface - can heat the air by 1-3°C||Vanes are heated by an electrical heating cable to prevent freezing and allows drainage of collected water.|
Although summer is a few months away in some countries, you can prepare for next year by installing the right anti-icing system for your local site conditions.
Depending on your current filter solution and operational requirements, the anti-icing application may change. For recommendations on the optimal application for your site, contact your local representative.
Upstream: placed in front of the air inlet filter system
Downstream: placed behind the filters and protects only the bellmouth